![]() The printer will boot up like normal skipping firmware download and communication diagnostic mode. Release the feed button when LED is in Amber When the status light begins to slowly flash between red and green is when it is receiving the download the firmware. ![]() At this stage, the printer is ready to start downloading firmware and you can send the firmware directly to the printer.Release the feed button when LED Flashing Amber to Red At the various stage of the LED flashing Sequence will result in the printer entering that specific mode While the Printer is in the OFF state, Press and Hold the Feed key when the Printer is booting up. Perform Manual Calibration (Power ON Mode).Set the printer darkness (Power ON Mode).Set the printer print width (Power ON Mode).Reset to factory defaults (Power ON Mode).Reset the serial communications parameters (if it has a serial port option) (Power ON Mode).Enable label calibration (Power ON Mode).Print a Configuration Label (Power ON Mode).The Feed Button can be used to enable functional modes allowing you to configure or print the following: The below function can be triggered in the following mode: GC Series, GK Series, GX Series Printers Resolution / Answer G-Series Printer Feed Button Mode Details Applicable To
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |